Metalfab Bin Activator Manuale Utente Scaricare il pdf

INSTALLATION AND OPERATING INSTRUCTIONS

METALFAB BIN ACTIVATORS

Description

1. Upper hanger (suspension arm) brackets are pre-assembled, at the factory,

to a flanged cylindrical section. It insures proper alignment of the suspension

arms and sleeve clamping surfaces.

2. Flanged mounting ring may be provided with bolt holes for bolting to a

mating flange on the bin.

Note: Nuts, bolts and gasketing for the mating flanges are not

supplied by Metalfab. Use high strength, grade 5 bolts

and locknuts.

3. When being installed on a conical section of a bin, it can also be welded

directly to the bin cone. The cone may be butted against the horizontal or

inside diameter of the flange and seal welded.

4. Before doing any welding, remove the vibrator from the Bin Activator.

5. In all cases, regardless of installation procedures, the mounting flange must

not be distorted or bent during installation.

6. Even though the locating of suspension brackets is done with special

equipment, it is recommended that mating parts be maintained, i.e., do not

interchange mounting flanges from one serial numbered unit with another

serial numbered unit.

7. To insure proper fit and alignment, plan view orientation of the hopper

mounting flange with relation to the Bin Activator must not be changed.

8. In most cases, generally 3 foot through 8 foot diameter units, the mounting

flange is shipped pre-assembled to the Bin Activator. For 10 foot diameter

and larger, the mounting flange is split in half and shipped on the same skid

as the Bin Activator or separately. A metal brace may be welded to each half

section to prevent distortion during shipment. If so, remove after installation.

1 2 3 4 5 6

Sommario

Pagina 1 - Description

1INSTALLATION AND OPERATING INSTRUCTIONSMETALFAB BIN ACTIVATORSDescription1. Upper hanger (suspension arm) brackets are pre-assembled, at the factory

Pagina 2 - Installation _ Assembly

2Installation _ Assembly1. Specific sequence of installing a Metalfab Bin Activator can be changed tosuit individual requirements. Most important is

Pagina 3 - Vibrator Installation

38. When installing units not completely assembled, the correct procedure is tocompletely assemble the unit at grade with the following procedure:A.

Pagina 4 - Vibrator Force Adjustment

42. Because the Bin Activator and the motor vibrate, the electrical connectionsmust be made with flexible lead. Braided neoprene covered cable isrec

Pagina 5 - Maintenance Instructions

5Note: Bin Activator vibrator should be electrically interlockedwith down stream feed devices, i.e., when screw, belt,rotary, etc. feeder stops _ vibr

Pagina 6 - EVACUATED AND AVOIDED!

6WARNING: Because of the elastomeric seals required on vibratedequipment, the Bin Activator WILL NOT CONTAIN A FIRE OREXPLOSION. If a fire is in the

Commenti su questo manuale

Nessun commento

Metalfab Bin Activator Manuale Utente

Navigare online o scaricare Manuale Utente per Apparecchiature Metalfab Bin Activator. Metalfab Bin Activator User Manual Manuale Utente

Sommario

Commenti su questo manuale

Prodotti e manuali riguardandi Apparecchiature Metalfab Bin Activator